Case IH 265 Offset Tractor Official Operator’s Manual

TO THE OWNER OF A CASE IH TRACTOR
SERIAL NUMBER
TABLE OF CONTENTS
SAFETY 
Safety Rules
Decals
Before Starting
Operation
Service
HAND SIGNALS
NOTES
DIESEL ENGINE SPECIFICATIONS
GENERAL TRACTOR
SPECIFICATIONS
TRAVEL SPEEDS – 265 OFFSET
TRACTOR
APPROXIMATE MEASUREMENTS
AND WEIGHTS
TIRE AND WHEEL
SPECIFICATION
Tire Inflation Specifications
Tire Load Capacity
FRONT WHEEL TREAD POSITIONS
REAR WHEEL TREAD POSITIONS
WHEEL MOUNTING TORQUES
DIESEL FUEL SPECIFICATIONS
Specifications for Acceptable
Number Two Diesel Fuel
Fuel Conditioner
INSTRUMENTS AND INDICATORS
OPERATING CONTROLS
Control Pedals
Control Levers
Operators Seat
Amber Warning Lamps – Direction
Tum Signals and SMV Emblem
Implement Warning Lamps
SMV Emblem
Mid Work Lamp
Rear Work Lamp (If Equipped)
Sever Conductor Electrical
Connector (If Equipped) 
OPERATING INSTRUCTIONS
Run-In Procedure
Towing 
How to Transport Tractor
BEFORE STARTING THE ENGINE
NORMAL STARTING
PROCEDURE
STOPPING THE ENGINE
COLD TEMPERATURE
OPERATION
Coolant Heater
SEAT BELT
ROLL OVER PROTECTIVE
STRUCTURE (ROPS)
Foldable ROPS Frame
Normal Operating Posit:on
Low Clearance Positions
Folding the ROPS
Securing the ROPS in the
Upright Position
Tractor Roll Over
Safety Rules
ROPS Label
TRANSMISSION CONTROLS
Transmission Operation
DIFFERENTIAL LOCK
POWER TAKE OFF (PTO)
Rear PTO
Mid PTO (If Equipped)
LIVE PTO (IF EQUIPPED)
POWER TAKEOFF GUARDS
PTO OPERATING SAFETY
DRAWBAR
CONNECTING IMPLEMENT
TO DRAWBAR
SAFETY CHAIN
THREE POINT HITCH SYSTEM
HITCH SYSTEM ADJUSTMENTS
Lift Links and Turnbuckle
Upper Link
Stabilizer Chain
HITCH OPERATION
Connect Implement to Hitch
Disconnect Implement
from Hitch
Rear Hitch Control Lever
Mid Hitch Control Lever
Draft Control Lever (If Equipped)
Operating with Draft Control
Rear Hitch Lowering Speed Adjustment
REMOTE HYDRAULIC CONTROL VALVE (IF EQUIPPED)
HYDRAULIC ADAPTER PLATE
ADDING FLUID AFTER CONNECTING
CYLINDERS AND HOSES
FRONT WHEEL ADJUSTMENTS
Front Wheel Tead Adjustment
Toe-In Adjustment
REAR TREAD ADJUSTMENTS
TRACTOR BALLAST
Front End Weights
Rear Wheel Weights
Tire Liquid Weights
LUBRICATION AND PREVENTIVE
MAINTENANCE
LUBRICATION
Engine Hourmeter
Service After First 50 Hours of
Operation
HOOD
ENGINE LUBRICATION
Service Specifications
Engine Oil Level
Engine Oil Change
Engine Oil Selection
Engine Lubrication Oil Viscosity
Engine Oil Filter
TRANSMISSION AND HYDRAULIC
LUBRICATION
Service Specifications
Transmission Oil Level
Transmission Oil Change
Hydraulic Filter
FRONT WHEEL BEARING
LUBRICATION
Service Specifications
TIRE AND RIM SERVICE
Service Specifications
Tire Inflation Procedure
Tire and Rim Repair
Tire Installation
COOLING SYSTEM
Service Specifications
Pressure Cooling System
Cleaning the Cooling System
Coolant Solutions
Coolant Solutions
COOLING SYSTEM
Coolant Solutions
Grille Screen and Radiator Area
Thermostat Check
Thermostat Replacement
Fan Belt Adjustment
Fan Belt Replacement
FUEL SYSTEM
Service Specifications
Water Removal from the Filter Cup
Fuel Filter Element Replacement
Fuel System Air Removal
Fuel Injection Pump and
Nozzle Check
AIR INDUCTION SYSTEM
Service Specifications
Dust Container and Ar Filter
Element Removal
Element Cleaning
System Inspection
CLUTCH CABLE ADJUSTMENT(WITH LIVE PTO)
Service Specifications
CLUTCH PEDAL ADJUSTMENT (WITHOUT LIVE PTO)
NEUTRAL START SWITCH
ELECTRICAL SYSTEM
Head Lamps
Turn Signal and Flasher Lamp
Rear Red Lamp
Mid Work Lamp
Fuses
Fusible Link
Head Lamp Adjustment
General Service Information For
Alternator Charging System
BATTERY
Access to Battery
Auxiliary Battery Connections
Battery Cables and Terminals
Removal and Installation of Battery
When Charging the Battery
When Battery is Not in Use
OPS EQUIPMENT
Service Specifications
ROPS Inspection and Maintenance
Seat Belt Inspection and Maintenance
COOLING SYSTEM
STORING THE TRACTOR
Coolant Solutions
REMOVING FROM STORAGE
Grille Screen and Radiator Area
CASE TECHNICAL MANUALS

========================================